Return DIP switches #1, 5 and 6 to off (original) position.The HP ProLiant D元60 G7 combines performance, intelligent power and cooling management with IT management tools and essential fault tolerance, all optimized for space constrained installations.Turn DIP switches #1, 5 and 6 switch on.Return DIP switch #6 to off (original) position.

Power on the server and allow it to idle for 3 minutes.Locate the System Maintenance Switch on the motherboard - It's a set of 10 DIP switches.Remove all power supplies from the chassis.Remove the power supply units and swap them.If you have physical access to the server, you can try this sequence: It's a weird one, and it takes a bit of patience, but please follow the steps listed at: HP ProLiant D元80 G7 servers will not POST In the past when it has turned on it did so suddenly after thorough prodding, but without touching the power button.Īnyone seen anything like this before? Is this machine doomed to sit with it's one amber eye staring into oblivion? Should I just accept that trying to resurrect a 6 year old server that's now going for sub-$200 prices on ebay maybe isn't worth it? Have I shamed it into a non-functional state with my offensive and often out-dated slurs? Will I ever run out of one-liner questions? Time will tell.

Almost as if the fault strikes several seconds after power is applied. The UID light doesn't respond when pressed, except when it's first plugged in. ILO appears to be non-functional in this state, and when I was able to get into back when it worked there were no faults recorded.

Breaking the server down to minimum configuration.

Pulling the procs and reseating them both in the primary socket to determine if one is perhaps bad.

Now I'd like to get it on again and the problem is back. It was running just fine for a number of months before I turned it off simply because I didn't need it. Since that night it's been part of my test environment. I say the latter because it hasn't been consistent since. I finally got the thing to boot through a combination of breaking it down to minimum configuration, cursing, and dumb luck. I got the 10 PM call that something was wrong, stumbled to the datacenter, and found this server in a boot loop flashing on and off. It all started around a year ago when it was in production. I've got an HP DL 380 G6 that has been having strange intermittent issues.

Hp dl360 g6 ilo